Flaming Hot???

[cpals]

I'm trying out MotherBoard Probe with my new ECS k7s5a because a few people have been using it. My mobo is reading at 33C and my cpu is at 46C when idle. When I get a little resource intensive it goes up to about 55C (the cpu). is this too hot? I have a WBK38. All of the voltage settings seem to be messed up so I haven't been using those.

 

[Wind]

55C huh...I have the same HSF for Duron 800@968. f/load is only 53C, mobo temp 40C. Wht termal compound u have there? R u using the termal pad supply w/ the HSF? If yes, then scrap the pad off & apply ASII. This should lower ur temp a abit. 2nd, better case cooling will help as well. 1 80mm intake fan in the front of the case & 1 80mm exhaust at the back of the case should do the trick.

 

[cpals]

I am using Arctic Silver II. I was just wondering how hot is too hot for my 1.4? I would think if yours is 53C then mine is pretty cool since my processor runs much hotter than yours. Maybe I'm missing something though.

Thanks.

 

[cpals]

My settings for MBProbe are (at idle):

SiS950:1 = 26C
SiS950:2 = 33C
SiS950:3 = 48C

Just to make sure... what one is my processor reading?

Also, my vccp2 is at 2.48 and my -5 is at -1.59

I appreciate any help.