Few Questions

[Cook1]

Alright, have a few questions, going to try to organize them the best I can!.

#1

I have the MSI K8N Neo Platium 2 motherboard. I'm not finding a place where I can adjust the ratio of cpu/dram in the BIOS. I have 2x512 of PC3200 and 2x512MB Geil Ultra PC2700. I want to run all 4 sticks at PC3200. In CPUZ it says I'm running my memory at a 161 Frequency and under the FSB: DRAM ratio I'm at "CPU/14.0". I'm not OCing this CPU, it's a 3500+ Newcastle so I would like to run it at a 1:1 ratio, but for the life of me not finding the option in the BIOS. Anyone albe to give me a clue with this one?

#2

Speedfan question now. I've used it in the past, and always the first temp, the temp that goes down near the time display has been the CPU temp. Going from right to left my temps read as follows...

"27C, 34C, 28C, 27C, 26C"

I know the last two are the HD temps, and I know the two 27Cs are my case temps, how do I go about putting the 34C in front of so it shows up down near the time?

#3

I have 2x80GB SATA HD's, I haven't installed the RAID drivers because I don't want to use them in a raid. The little green arrow icon that appears down near the time when you put a flash drive appears with these two HD's. How do I go about getting that thing off?

#4

Fresh install of XP Pro and I'm getting the application error CLI.EXE any ideas on this?

#5

Also, at load I get up to 58C, which I know is fine, but not for me. Can anyone suggest a better HSF then the TT K8 for around $50?

Thanks all

 

[Cook1]

 

[Cook1]

 

[furie27]

I think I can help with two of your questions/ First, in the bios there should be a way to set the memory clock to ddr400, assuming your pc2700 can handle the o/c. On my MSI Neo KT800, it's in the advanced bios options. Second the cli error, I'm assuming comes from the ATI control panel software. It needs the updated .net framework from Microsoft to run properly.

Hope that helps.

 

[Cook1]

On my MSI Neo KT800, it's in the advanced bios options

It's strange, I go into the memory config place, and it has a place for me to put my max memory frequiency, which I put to 200MHz, and since I'm running my CPU at a 200FSB I'm thinking htat I'm missing the cpu: dram ratio thing. So if someone could help with that, that would be just super!

And doing the widows update thing now, will let ya know if it works, and thanks for the advice.