Ok, so here's my setup: Epox 8k7a with 1.2 tbird, 256mb ram, all new drivers, original bios, two wd hard drives (30 gb each) a cdrw, a floppy, and a zip drive. If I connect everything but the zip drive it works fine, but with the zip drive plugged in anywhere on any chain on slave or master, it makes my windows startup screen take approx 15 minutes to load, with lots of freezing in the process bar. Also, my ata66 promise ide expansion card will detect none of my devices on it, and it gives me the message that "No ATA66 compatible bios is found" so Im screwed there too, installed all new drivers for that, only thing I havent done is flash the card's bios, which I will try next. Lastly, the mobo will not detect one of my hard drives as ata66, only 33, even though it is certified at 100. So any suggestions? I could use some. Thanks