• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

EpoX 4G4A+.. where's the 4:5 memory setting?

A

aGeNt73

Senior member
hi everyone, i been reading that people are using 4:5 memory settings for oc'ing their 1.6a on the EpoX 4G4A+.

I only have 1:1, and 3:4 on my EpoXX 4G4A+. Am i using the wrong bios or did i get a wrong revision?

i have the 6/17/02 bios.. thanks 🙂
 
Remove jumper JP1 (located between the ATX connector and northbridge) to force 133FSB, and the 4:5 divider will magically appear. 🙂
 
Hey,

I have a related problem with the same board and a P4 2.0A. When I remove JP1 my system does not post, and instead goes into loud siren-like beeping. I haven't been able to switch over to 133mhz so I can access the 4:5 ratio...

Any suggestions?
 
When you remove the jumper, you force a 133mhz FSB. It wouldn't be surprising if your 2.0a cannot run on a 133mhz FSB.
 
I am getting this board and would like to know if you only have that ratio at 133 or is it 133 and above. (I definately plan on going above.)
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top