Epox 4g4a+ and ddr333? plz help

[brunswickite]

i know lots of peopel own this board, and had a question, when u put ddr 333 in this board
waht do u do to make its running ddr 333
becase it does not officially support it

thanks

 

[brunswickite]

This post seems quite incoherent, i am very sleepy right now so thats my excuse.

Basically to sum it up, when i get my Epox 4g4a+ and put in my ddr333 RAM
how will i know its running hte RAM at ddr333?
waht do i ahve to set in the mobo bios to make it run at ddr333?

thanks

 

[nightowl]

To get DDR333 you need to have 2 things setup correctly. 1) The FSB has to be either 166MHz, 133MHz, or 125Mhz. 2) If the FSB is 166Mhz then the memory ratio is 1:1 with the FSB. With a 133Mhz FSB it is 5:4 and with 125Mhz it is 4:3. On the 4G4A to get the 5:4 ratio you need to set the jumper on the motherboard for 133Mhz.

 

[Liquidreign]

I was thinking of getting this board I have one question I have heard that this board has some problems sometimes when more than one stick of memory is installed thats the only negative i have heard about this board, can anyone offer any info on this.Thanks

 

[Tummy]

Most 845G motherboards have issues when running > 1 stick of ram and oc'ing. I've seen it personally with my 4g4a and also an 8igx. and have heard many other horror stories.

Also, a lot of 845g boards right now have issues when using 3:4 or 4:5 ram ratios with the intel INF's and vid drivers at generally around 150fsb or so.