Enlight 7237 Power Supply Question

GtPrOjEcTX

Lifer
Jul 3, 2001
10,784
6
81
Just got this case in hold the following:

ECS K7S5A mobo
AMD 1600+
generic floppy

Well, that's all that's in it right now except for my testbed video card (8mb nVidia Vanta LT)

And Got it to post up and everything, the chip defaulted to 1050mhz though, had to change the settings on mobo to run the memory and the chip at 133/133 instead of 100/100. Heh, and when I did so the degrees went up from 43 to 49 (with side panel off).
That's with a retail heatsink and fan. I happened to have a delta 38cfm and a y.s. tech 40cfm laying around (but no long screws to put them on the retail heatsink)

So i just plugged one then the other onto the motherboard and held it over the other fan. The 38cfm dropped it down to around 46-47 while the 40cfm got it down to 44. This would have been better off course had the other fan not been there.

ANYWAYS, back to my original question.

The power supply had a cord on it with 4 little prongs (wrong word?) in a square. (like below) I've never seen such a cable before. Is it something for a P4 or what?

_____
|__|__|
|__|__|
 

Migroo

Diamond Member
Jul 14, 2001
4,488
9
81
Yeah, for a P4, I got one of those too and I kinda just ignored it as I wasnt sure what it was for :)