• We’re currently investigating an issue related to the forum theme and styling that is impacting page layout and visual formatting. The problem has been identified, and we are actively working on a resolution. There is no impact to user data or functionality, this is strictly a front-end display issue. We’ll post an update once the fix has been deployed. Thanks for your patience while we get this sorted.

ecs rs482-m dead

D

ddmo

Junior Member
Just purchased this board. Has built in ATI graphics. Was winflashing a new bios and it did not work (verify after programing failed). Tried several times, now when I boot, I get beeps. I created a boot floppy with the flash software and old bios on it, when the system gets powered on, it beeps, then accessess the floppy, sounds like it is loading the system software, but I get no display on the monitor. Any ideas what to do? Is there a boot disk creator for the 482-m with the integrated ATI graphics?

Thanks for your help.

DDMO
 
Try clearing the CMOS with the jumper. That may reset it to detect your setup correctly.

Are you using the built in graphics? If so, you may have to try booting with another vid card. Almost any card will do. If you get any video, immiately go to the CMOS to check the settings. If it is set to use an external vid card, reset it to use the internal video setup as the default.

If you're using an external vid card, you may need to reverse the above process and temporarily use the onboard video to reset the CMOS to use your external card.
 
Tried clearing cmos with jumper and a PCI video card I had. Still no video. Moved pci video to other pci slots, but still no video. Any other ideas?
 
You must log in or register to reply here.

TRENDING THREADS

Back
Top