ECS K7VZM and USB header

[kaldor01]

I am installing a new ECS K7VZM into a new case, and I want to make
use of USB ports 3&4.
The USB header is made of 2 rows of 5 pins each. The cable that comes from the USB bracket, has 2 rows of 5 holes.
How do I know which way to plug in the connector onto the USB
header ? It can go in both ways, and the owner's manual does not
have the pins numbered.
Please help.

 

[kaldor01]

I dont beleive no one can answer this question for me.

 

[Modus]

Is there no red wire on the header? Any red or white wire or mark indicates "pin 1". Similarly, the board should have a white mark or notch silkscreened on to indicate pin 1 of the header. The manual would certainly tell you, as well.

Modus

 

[kaldor01]

Well, the manual tells you nothing. The pins are not even numbered.
I do see a white line on one side of the connector, so I assume that side
is where pin #1 should go.
There are 2 red wires on one side and 2 blacks on the other. So the RED is pin 1, correct ?

 

[Modus]

You got it.

Modus