ECS K7VTA3 rev8 won't boot up.

[MuffD]

Okay, I tried 3 different types of working memory and all don't work with this board. I have tried the DDR 400 and DDR 333. Neither is helping. I have this board, the XP2000, ATI All in Wonder 8500DV, WD 80gb hd, Liteon DVD/CDRW combo as my bare minimum of devices installed. The cpu has been tested with another board just like the ram. The power supply is some 350 watt ps that I was using before my Asus board burned out so I'm wondering if that could be the problem. when I try to boot up, you hear a long beep, and two short beeps. The monitor doesn't even get a signal. I also checked to make sure the jumpers were set to 133mhz like the manual. This board is rev 8.0
Can anyone figure this out?

Thanks

 

[Peter]

"Bare minimum" is CPU, fan/heatsink, RAM, graphics card. Try that. And don't forget: You need to have the "CMOS Clear" jumper on Normal, the CPU fan plugged into the CPUFAN header, and the power switch connector on the Power Button header.

 

[MuffD]

Hi
Problem got fixed! I had to disable the firewire port in my ATI AIW 8500Dv.