ecs k7s5a power led connector only has two pins?

[igowerf]

I just put in my shiny new ECS K7S5a and I start plugging in the LEDs and power/reset switch connectors when I notice that the board's power LED connector only has two pins. My Inwin Q500 case has a 3 pin connector as does my Enlight 7237. The middle hole doesn't have any contacts in it so only the two outer holes actually do anything. What am I supposed to do now? I could cut the power led in half and plug it in but I'd rather use a converter or something.

 

[Quickfingerz]

there is a way to remove the pin and place in another place so that they are right next to each other ( instead of having the bland middle pin you remove the pin and place it there)

 

[Gunbuster]

Push the wire in, at the same time take pin or another small object and lift up the little tab on the black plastic block, then pull out the wire and slide it in the connector port you need it in

 

[igowerf]

Thanks for the tip. I figured that out after poking and prodding for a little bit. It works now.