Duron 700 won't boot up

[aniki]

I am having trouble with FIC AZ11 with Duron 700 that won't boot up. Everything runs, but I cannot seem to get video at start up. I am using crucial memory. I switched memory to different slots, even used different memory. Used a TNT2 video card and an Intel 740 AGP. But, still no video. Also tried two different monitors. Can't figure out if it could be the motherboard or the processor that may be malfunctioning. Suspect motherboard because no beeps are heard. Any help with this will be greatly appreciated.

 

[formulav8]

Does that board have any trouble shooting led's or anything like that?

 

[aniki]

led doesn't work, power led doesn't come on.

 

[formulav8]

Sounds like a dead board.

 

[aniki]

what makes you think that?

 

[Ausm]

Did this setup run before or did you just build it?>

 

[aniki]

just built it, everything is new

 

[billyjak]

Do you have the jumper on 133 or 100, if on 133 it will not boot up, change it to the 100 jumper setting as in the manual.
I woud reset the bios with the jumper pins also and make sure they're on the default setting.

 

[aniki]

No, its running at 100 and I reset the bios and the jumper pins are on the default setting.

 

[gtd2000]

Have u unplugged the power cable and reset the CMOS jumper?
.......then plug back in the power cable and try to boot - weird stuff but many Socket A motherboards REFUSE to boot if you don't do that....don't ask me why???? 🙁

 

[limsandy]

is the fan working ?
if not, then it's a dead mobo.

 

[aniki]

the fan works

 

[Jeff7]

Take off the heatsink on the CPU and make sure it hasn't been badly chipped or cracked.

 

[Biggs]

Make sure your memory are installed correctly.

 

[gtd2000]

reset the "BIOS" or reset the "CMOS"?

 

[Ausm]

Make sure the mobo is not grounding out in the case....in fact remove it from the case just have the CPU,Memory,vid card in it and fore it up and see what happens. Oh make sure the mobo is on a nonconductive surface also.

Ausm

 

[GreeNeEyEs]

Dead mobo

 

[aniki]

Make sure the mobo is not grounding out in the case....in fact remove it from the case just have the CPU,Memory,vid card in it and fore it up and see what happens. Oh make sure the mobo is on a nonconductive surface also

Still nothing

 

[limsandy]

Oh, so sad.
Check list:

Make sure that the power supply voltage is set to 110 V
Apply thermal grease on to the CPU and if possible onto the chipset.
video card is plugged in properly
Memory modules are fully inserted

Let see..... what else?

 

[MrDudeMan]

if you are having this much trouble, just get a new one. i dont think its worth all this trouble because every step that can be taken to get this baby to work has already been said, i think

 

[aniki]

I have to agree with you. Thanks for trying.

 

[gtd2000]

This IS a very common problem with socket A boards though........... 🙁