Dolly Barton Goodness

Discussion in 'CPUs and Overclocking' started by Pseudodominion, Jun 14, 2003.

  1. Pseudodominion

    Pseudodominion Golden Member

    Joined:
    Nov 15, 2001
    Messages:
    1,160
    Likes Received:
    0
    2500 bartons modded for MP. OC'ed to 2240Mhz@ 1.7v Running Prime tonight to test this clock. I doubt I will push for more. With 2 bartons running at this speed in one case, thats alot of heat to exhaust.

    Check it out.
     
  2. TitaniumZX

    TitaniumZX Junior Member

    Joined:
    Jan 31, 2003
    Messages:
    7
    Likes Received:
    0
    Why don't you try to up the FSB and lower the multiplier? I'm running mine at 215 X 11 at stock voltage.
     
  3. AnImuS

    AnImuS Senior member

    Joined:
    Sep 28, 2001
    Messages:
    939
    Likes Received:
    0
    Because it looks likes hes using a AMD MPX board... The boards dont overclock much 150FSB is usually the limit except with the Iwill board... Also not sure if you know or not but only 1 board supports changing the multiplier(through bios) and thats the MSI upto 12.5...
     
  4. Pseudodominion

    Pseudodominion Golden Member

    Joined:
    Nov 15, 2001
    Messages:
    1,160
    Likes Received:
    0
    As has been stated I can't change the mult. through bios. I need to reconnect and blow bridges for these settings. Dual platforms don't go as far in FSB as single nF2 solutions. This is an I will and can go slightly above 150 but lacks the correct dividers for PCI to make a totally stable OC on the FSB, and well stability wins out over a fast bus IMO.