beatle
Diamond Member
Finding that my chip will likely only work @ 2.4, I decide to see what my BH5 memory will do @ 2.8v. Might as well shoot for 240mhz, 3-3-3-8. I set the values in memory and boot. Black screen. I power off for a minute, then power on. Black screen. 😕 I hold the shift key, delete key, ctrl key, f12, f2, whatever I can think of to get this to boot back up so I don't have to dive into the case.
After 15 minutes of fiddling and searching for instructions on how to use this feature, I reset my bios the old fashioned way and boot back up. I doubt I'll have to do this again, but I'm curious if this feature is worthless or if I'm missing a crucial step. The manual just says I have to power off and back on.
After 15 minutes of fiddling and searching for instructions on how to use this feature, I reset my bios the old fashioned way and boot back up. I doubt I'll have to do this again, but I'm curious if this feature is worthless or if I'm missing a crucial step. The manual just says I have to power off and back on.
