Do you use Dremel for the entire job? Or other tools?

[jspeicher]

I'm thinking about getting into case modding. I know that a dremel is a great tool for engraving, sanding, etc, but do you guys use it to cut entire case windows? Or do you use a jig saw of sorts for most of the cutting?

 

[deerslayer]

Jigsaw for windows, hole saw for blowholes.

I haven't used a dremmel for anything yet, except cutting out stock fan grills on the case chassis. Some people use nibblers too.

If you do a search you should be able to find more info on this.

 

[JesDer]

I use dremels for just about everything.



This was about 90% done with a dremel


for really large cuts jigsaws work well. Scrollsaws work good for large cuts an a decent amount of detail.

Dremels can do just about anything however they are not always the best tool for the job.


if you want .. check out my dremel guide here

 

[pelikan]

I use a jigsaw for everything.

 

[huesmann]

Originally posted by: JesDer
This was about 90% done with a dremel

Dizzam! That's good work!

 

[BG4533]

Originally posted by: JesDer
I use dremels for just about everything.



This was about 90% done with a dremel


for really large cuts jigsaws work well. Scrollsaws work good for large cuts an a decent amount of detail.

Dremels can do just about anything however they are not always the best tool for the job.


if you want .. check out my dremel guide here

Thanks for the guide. I was looking for one the other day. Good work too.

Brian

 

[KouklatheCat]

I use a holesaw for my fan holes, jig saw for cutting windows in aluminum cases. I use a dremel for cutting steel cases, especailly for getting rid of those stamped in fan grilles. Get a cheap or an old case and practice hacking it up to get the feel of the different tools.

 

[isaacmacdonald]

yep. also, make sure you use the right techniques for each tool. The dremel, in particular, doesn't react well to brute force cutting. It takes a substantial amount of effort to get a good clean edge and any sort of accuracy for straight lines and such. The hardened carbide tip (for cutting steel) is particularly difficult to handle at first. If you are planning some cool intricate design (as seen above), I would recommend some extensive practive before you set to hacking up your $100 case.