I am putting together a little system in the living room for my wife as she loves to read on the couch listening to music and with the A2 massdrop deal I figured this couldn't be a better time to do it.
I putting A2's on a custom bookshelf her dad made her and want to make a DIY sub into a side table. Her dad is a master woodworker so he can help me with making the enclosure of the sub into a side table but trying to figure out how to get it connected and what plate amp to use.
Equipment:
Fiio E10 connected to an old PC that will be put inside the side table out of sight.
Audioengine A2
DIY sub will consist of Dayton 10" Reference HF.
http://www.parts-express.com/pe/showdetl.cfm?partnumber=295-460
My question is in regards to the amp I was thinking of using which is this one:
http://www.parts-express.com/pe/showdetl.cfm?partnumber=301-510
The amp has built-in 6db boost at 30Hz as this will be a sealed enclosure.
Sub will be mounted in a down-firing config.
As far as the connections of the amp goes am I right to assume that it will go connected to the speakers like this:
E10 line-out -> line-in plate amp -> line-out plate amp -> line-in A2
Setting the sub to ~90Hz crossover the speakers should receive the right signal?
I putting A2's on a custom bookshelf her dad made her and want to make a DIY sub into a side table. Her dad is a master woodworker so he can help me with making the enclosure of the sub into a side table but trying to figure out how to get it connected and what plate amp to use.
Equipment:
Fiio E10 connected to an old PC that will be put inside the side table out of sight.
Audioengine A2
DIY sub will consist of Dayton 10" Reference HF.
http://www.parts-express.com/pe/showdetl.cfm?partnumber=295-460
My question is in regards to the amp I was thinking of using which is this one:
http://www.parts-express.com/pe/showdetl.cfm?partnumber=301-510
The amp has built-in 6db boost at 30Hz as this will be a sealed enclosure.
Sub will be mounted in a down-firing config.
As far as the connections of the amp goes am I right to assume that it will go connected to the speakers like this:
E10 line-out -> line-in plate amp -> line-out plate amp -> line-in A2
Setting the sub to ~90Hz crossover the speakers should receive the right signal?
Facebook
Twitter