Did I ruin my Wrt54G?

[Falloutboy]

I installed a flashed Firmware on it at my old apartment to make it act like a bridge and it worked fine. I moved to my new apartment and keyed in the info to the new network I would be using it on and when it rebooted I no longer can pull a IP from it I tried doing in manually but I still can't connect to the router

I tried the reset button in the back of it and still no luck in getting it to allow me to connect to it. any other ideas I'm fresh out. I must of keyed something in wrong because it worked fine before this mess now it won't do crap and I can't figure out how to undue what I did

 

[Fullmetal Chocobo]

Originally posted by: Falloutboy
I installed a flashed Firmware on it at my old apartment to make it act like a bridge and it worked fine. I moved to my new apartment and keyed in the info to the new network I would be using it on and when it rebooted I no longer can pull a IP from it I tried doing in manually but I still can't connect to the router

I tried the reset button in the back of it and still no luck in getting it to allow me to connect to it. any other ideas I'm fresh out. I must of keyed something in wrong because it worked fine before this mess now it won't do crap and I can't figure out how to undue what I did

I fought like this for a long time while setting up my crack rack. Did you hold the reset in for atleast 10 seconds? Also, sometimes I couldn't connect, so I had to use the setup on the installation CD, and it worked after the reset.

 

[JackMDS]

http://www.hyperwrt.org/wiki/RecoverFromABrick

:sun:

 

[Falloutboy]

thanks just needed a hard reset and didn't relise it was such a bitch to get it to do it