DH67CF concurrent DVI & HDMI

[Anosh]

Hi!
I just got this board and I hooked it up to the tv with hdmi for a short while waiting for a monitor to arrive and it worked fine. Now the monitor has arrived and I connected the board through DVI to the monitor and through HDMI to the TV.

The problem is the board stopped sending a picture to the TV and the intel software doesn't even see anything connected on the HDMI.. How do I enable concurrent DVI and HDMI on this board?

 

[IntelEnthusiast]

Here is the TPM for the Intel® Desktop DH67CF. On page 20 is the information on the video set up. I seem to remember hearing about some issue with a DVI-I in analog mode with a digital signal (HDMI) may not work together in some boards. I dont see this listed anywhere on the board so you can give our Technical Support Group a call at 916-377-7000 and they should be able to help you figure this out.

Christian Wood
Intel Enthusiast Team

 

[piasabird]

Why dont you just go to the INTEL forum on intel.com? That is what I would suggest.

 

[Anosh]

I hooked the hdmi port to a KFA2 StreamHD and I cut the power to the receiver and then reconnected it; which caused the motherboard/OS to detect the TV.

 

[Anosh]

Just to clearify things.

The issue was more with the kfa2 streamhd rather than the board. There is a button (source?) on the remote (that came with the kfa2) that iniciates a manual connection between the hdmi dongle attached to the board and the receiver attached to the TV. Pressing it makes the board detect a hdmi signal in the hdmi port and see the TV. Which then allows the intel HD graphics software to see and setup/use the config for the TV.

 

[Yorkfield]

Hi, do you think your issue might be related to this one in any way?