DFI Ultra-D owners: What RAM works with this board?

[slash196]

So my Value Select has been a nightmare with my Ultra-D. Random reboots, BSODs, and crashes galore(even in memtest!). So I'm giving up on it and sending it back. For those who haven't been burned, what RAM are you using. I'd sure like to finally get this rig running right.

 

[jose]

See sig... The patriot XML ram is very good w/ the DFI mobo. Right now my a8n-sli is DOA POS...

I'm not oc'ding the DFI until a official bios release, I don't want to mess w/ something that hasn't given me a single problem.
Currently using the bios that shipped w/ the mobo..

Good Luck.

Regards,
Jose

 

[thanatos355]

this is working great for me! i've been up a little over 2300mhz, but will wait to push it further till i get my xp-120 and some more info on the nf4 chip safe volt/temps.

 

[MTSteel]

Have you been to DFI-street.com and adjusted the BIOS to try and help the memory problems? RGone has a thread, http://www.dfi-street.com/forum/showthread.php?t=5844 with some BIOS adjustmests that have helped many with their memory problems.
The big one I have seen cure peoples is the MAX ASYNCH LATENCY = 7X. Try it and GL!

 

[Teetu]

yeah, check out RGone's thread. I have 1 gig of corsair value select, and ran through memtest flawlessly.

As MTSteel mentioned adjust the max asynch latency. I also turned off bank interleave (this is supposed to drop a lot of volts so "mediocre" memory runs), and I also set the read preamble to 5X. Rgone has some more settings, but those are the 3 I did in regards to ram to get everything running fine.

The only other adjustments I made was disabling cpu throttling, disabled errata, and move the pci payload down. Haven't had a hitch yet.