DFI, leadtek & drivers... Huge problem

[WHATjens]

I use a system of DFI SLI-DR mobo, AMD 3800+ venice, ocz pc4000 vx gold and leadtek 6800GT sli ready gfx card.

My screen is a viewsonic vp201b.

My problem is when i use dvi cable for my monitor and run in solutions higher than 1280x1024 i get wierd dots in som colors. Happens in blue areas and red/yellow areas.

I tried with another gfx card and i dont get the problem.

If i use a dvi > vga converter and the vga plug in the screen i dont have any problems in any solutions.

You can se an example of the problem at the picture i am linking to.

My best gues is some driver problemer or problem with using leadtek card and dfi motherboard.

I really hobe some1 has a clue about this its pretty anoying.

Picture of failure

 

[sniperruff]

check the pins on your connector.

 

[WHATjens]

what do you meen ?? do you think its a power problem ??

 

[WHATjens]

If u meen my dvi cable its not the problem i tryed with to cables and got the same error

 

[sniperruff]

it's a new build right? try installing the driver again.

 

[WHATjens]

Tryed 71.89, 71.84, omega drivers and i am now using the drivers from leadtek homepage also based on 71.84 🙁

And yeah its a new build

 

[WHATjens]

Nobody got a clue i could really use some help on this one....