DFI Lanparty NFII Ultra OC question

[sykopath79]

I am running a 2500+ Barton on a DFI "LanParty" NFII Ultra board (original version). I am wondering how it handles AGP/PCI bus clocking in relation to FSB speeds, because nowhere in the BIOS setup do I see a setting for PCI bus ratio. It simply has CPU multiplier & DDR DIMM clock (FSB) settings.

I have Mushkin PC3500 Level II (DDR433) and I'm currently running at 200x11; I want to bump up my FSB and run at 210x10.5 or 220x10 instead since I know the RAM can handle it with low latencies up to at least 217 FSB. My problem is I want to be sure that my PCI bus isn't being OCed at the same time - I want AGP/PCI locked at the normal 33/66 MHz.

Anyone familiar enough with the LanParty NFII board to know about this?

 

[AWhackWhiteBoy]

i can asure you the PCI and AGP will stay locked. its a featuer of the nforce chipset. i ran my revision B lanparty at 225 no problem.

 

[sykopath79]

Did you have to increase the chipset voltage at all?

 

[AWhackWhiteBoy]

i boosted the chipset voltage to make sure it was stable,then i slowly brought it back down, it ran 225 at stock voltage for me.

however, check my other thread, i have overheating issues. just be aware...