DFI Infinity II - Issues

ingenuiti

Member
Aug 1, 2002
189
0
0
I was able to build my computer several weeks ago but have noticed two issues that I can't figure out.

1. I'm running Windows XP and there is no option to put my computer into stand by mode. This can be observed from the start>shutdown menu and power options menu. I never had this issue with the other computers I have built, this option was always there by default.

2. This computer boots up successfully about half the time I turn it on. When it doesn't boot correctly into there is no visual output even at the bios level. All the lights to the system are on including the power and hd drive and it takes a simple reset to boot it up correctly.

Any thoughts on how to correct these issues?
 

DoobieOnline

Golden Member
Jan 12, 2001
1,397
0
0
Hey ingenuiti, check over here for LOTS of good info on DFI NF2 boards: link

I have the same board arriving on Wednesday, and I'm really hoping to escape some of the issues I've seen in the forums because the board has great potential. Good luck! :)