DFI C51PV-M2/G Infinity

[songokussm]

i recently built me a sff using the abit nf-m2 nview. i hate this board to the point it must be replaced. my brisebane 3600 can hit 3.2 on my DFI LANPARTY UT NF590 SLI-M2R/G. but on this mobo it doesnt even post after 250 htt......with my 4000 it posts at 270 htt. weird. were talking 251 freeze or 271 freeze. the 4000 hits 3ghz on my lanparty. same mobo just different chip.

with all the oc options turned down (1x htt, 8x up 8x down, ddr2 400, etc) the board will not post after 270. ive tried two different boards, same moddles. the first board i had to rma cuz it ran my chip at 1.5v.


so i need a new matx mobo. anyone have any experainces with DFI C51PV-M2/G Infinity?

i am using the Q-Xpack case and i know the infiity is larger then normal. will it fit? other sugestions on boards maybe?

the reason for the change -
1.) can not undervolt.
2.) very limited oc options. horrible memory deviers, htt settings, etc.
3.) bios crashes constantly. which requires a jumper reset. dfi does not have this issue.
4.) reports tempitures incorrectly. I have no idea what temps im running
5.) no profile save option.


i can explain further if need be.

i do apoligize for the spelling. im posting this after fighting with this board and just dont care anymore. i will correct it later.

 

[Brainonska511]

If the longer than a normal mATX board on the side parallel to the PCI slots, then it *should* fit fine (provided the standoffs are in the appropriate spots as well). If it is longer on the I/O panel side, then it will not fit.

 

[songokussm]

damn its longer on the io side. damn.