Ok, I have 4*512 Crucial Ballistix PC4000 memory.
Currently they are set up as dual channel, 2.5-4-4-10 @ 2.85V
This is the timing I get from CPU-Z too, and its SPD timings.
Crucial's website gives timings of 3-4-4-8 and 2.5-4-4-8 @ 2.8V but what they give on doesnt match my config - no. of modules and size of each module.
I was running at 2.5-4-4-8 and computer runs/boots/reboots fine, but if I power it off and start it again, I get long beeps at POST and I have to reset my BIOS.
Also CPU-Z says my memory freq is 130MHz ??? Shouldnt it be 250 MHz ?
here is the cpu-z report
https://mywebspace.wisc.edu/phora/web/cpuz1.htm
FSB
RAM = CPU/17
need help in fixing anything thats messed up....what should I put in the BIOS for memory, multipliers etc etc.
Bios is 1.9
thanks
Currently they are set up as dual channel, 2.5-4-4-10 @ 2.85V
This is the timing I get from CPU-Z too, and its SPD timings.
Crucial's website gives timings of 3-4-4-8 and 2.5-4-4-8 @ 2.8V but what they give on doesnt match my config - no. of modules and size of each module.
I was running at 2.5-4-4-8 and computer runs/boots/reboots fine, but if I power it off and start it again, I get long beeps at POST and I have to reset my BIOS.
Also CPU-Z says my memory freq is 130MHz ??? Shouldnt it be 250 MHz ?
here is the cpu-z report
https://mywebspace.wisc.edu/phora/web/cpuz1.htm
FSB
RAM = CPU/17need help in fixing anything thats messed up....what should I put in the BIOS for memory, multipliers etc etc.
Bios is 1.9
thanks
Facebook
Twitter