ok... been having a ton of problems recently. realized it was a faulty psu and thought it might have fried the 2 cpu's i'd tried in the system. took both to a local shop and tested them in a system there... retail 2400+ was dead... the 2600+ oem i had been using posted fine.
however... now that i have it home... in my system when i power it on it doesn't post/boot/beep... the system sits there for 4 or 5 sec then just shuts off. this is using a new PSU of course.
just wondering if anyone had any ideas of what i could do to fix this? the old faulty psu had been used on this system... so i suppose it IS possible it could have killed something else in the system... BUT... i'm hoping that isn't the case...
here's my current set up...
Antec Solution 430w retail
2600+ CPU w/SLK800A + vantec thermal controlled 80mm fan
1x 512MB Twinmos Twister pc3700
DFI Lanparty Ultra B
HIS X800 Pro
Mitsumi CDRW
2x WD 40gb drives
1x WD 10gb drive
2x UV cc's
2x 80mm exhaust
1x80mm intake
any ideas would be appreciated
however... now that i have it home... in my system when i power it on it doesn't post/boot/beep... the system sits there for 4 or 5 sec then just shuts off. this is using a new PSU of course.
just wondering if anyone had any ideas of what i could do to fix this? the old faulty psu had been used on this system... so i suppose it IS possible it could have killed something else in the system... BUT... i'm hoping that isn't the case...
here's my current set up...
Antec Solution 430w retail
2600+ CPU w/SLK800A + vantec thermal controlled 80mm fan
1x 512MB Twinmos Twister pc3700
DFI Lanparty Ultra B
HIS X800 Pro
Mitsumi CDRW
2x WD 40gb drives
1x WD 10gb drive
2x UV cc's
2x 80mm exhaust
1x80mm intake
any ideas would be appreciated
Facebook
Twitter