Corsair TX750W and GA_EP35-DS3R Mobo

[linux2011]

I have an Gigabyte GA-EP35-DS3R Rev 2.1 mobo and I just purchased a new Corsair TX750W power supply. Been having trouble getting the unit to boot up. The PSU has a 2X10 Power Connector with 4 additional pins attached to make it a 2X12 and I have the cover off the pins 11,12,23 and 24 on the mobo and actually have the Power connector connected to all 24 pins. The gigabyte manual is a little confusing saying it will support 2X10 and 2X12 but it also says that you need power to the ATX_12V connection to supply power to the CPU.

My power supply, does not have an individual connector that I can attach to the ATX_12V connection, to power the CPU. My question is; do they make a connector that will allow me to take a 8 PIN connector cable that I have on the PSU and convert it to a 4 pin connection to attach to the ATX_12V so it will power my CPU or is this possible? 😕

Basically I need some way to get 12v to the ATX_12v pins.

 

[BoomerD]

From the TX750 FAQ's on the Corsair website:

# Where’s the 4-pin EPS/ATX 12v connector that I need for my motherboard?

Our power supplies ship with an 8-pin connector that splits in half. Use half of this connector for the 4-pin EPS/ATX 12v connector on your motherboard.

http://www.corsair.com/power-supplies/non-modular-psus/enthusiast-series-1/tx750w.html

 

[linux2011]

BoomerD

You Rock !!!!!!!!!! I have searched high and low on Google looking for something on how to do this.

I appreciate the time you took to locate that for me.

😎

 

[BoomerD]

No problem...we're all here to help when we can.