Cisco 1841 Advanced Security Image = No ATM interface??

MulLa

Golden Member
Jun 20, 2000
1,755
0
0
Hi,

I've got a Cisco 1841 with an HWIC-ADSL card installed running on the standard ipbase image. Recently tried upgrading it to the advanced security version of the IOS but after doing that I cannot see my ATM0/0/0 interface anymore by doing a sh int command? When I put it back to the ipbase image it came back again.

Is this a "feature" of the advanced security image or am I missing something here?! :eek:
 

Pheran

Diamond Member
Apr 26, 2001
5,740
35
91
Are you sure that the advanced security image you loaded was the same code version as the previous image? ADSL HWICs were not supported until 12.4T, so you would have lost that support on the off chance that you downgraded to 12.4 mainline. If you're uncertain, post the output of "show version".