Check out new build!

[bokster]

Inspired by Dynamix 3D's P180 setup, I sought out to do the same with mine. I just finished the intial build and cleanup yesterday and this is the best I could do for now just with zipties!

Specs:
AMD Athlon 64 X2 3800+ @ 2.5ghz
Arctic Cooling Freezer 64 Pro
DFI Lanparty NF4 UT Ultra-D
eVGA 7800GT CO
2x1GB Mushkin XP4000 Black Series (3-4-3-8-1T @ 250)
Enermax EG565P-VE 535w FMA
300GB Seagate Barracuda 7200.9 SATAII
Antec P180

Here are some pics:
Upper Chamber
Lower Chamber
Ambience

I found the DFI board layout really tricky when trying to get a clean setup, I spent about 6 hours trying to find the neatest way possible with the tools on hand. I think it turned out pretty well except the top right where there is still a whole mess of wires. Any feedback would be much appreciated!

 

[narutofan36]

looks nice ^_^

do u have a pic of the case though >_<

 

[PhoenixOrion]

nice. need an angle shot on that CPU heatsink area.

 

[Powermoloch]

Very nice man, Dang I wish my mushkin XP 4000 were black too...except they are blue !!!!!!

Good ram btw 😉

 

[whitelight]

looks nice and neat... but it took 6 hours? 🙂

 

[KoolDrew]

:thumbsup:

 

[bokster]

Thanks for the positive feedback guys. I'm going to take some more pictures, but I'm going to try to fix it up some more too! It did take quite a while due to the fact that I had to spend lots of time trying to figure out the best way to fix it up. Putting it together didn't take very long.