Chaintech VNF4 ultra bios

[Oceanic]

ok so i flash to 2.0, and its supposed to have a bunch of great features and support ntune, which it does. but there is no cpu multiplier setting, and when i leave everything default, set fsb to 250, the multiplier is at 5x. heres where stuff goes stupid

windows says its a 3000+ at 2.0ghz which it should be

cpuz says its at 1.12 ghz (which is 5x) and voltage at 1.0/1 or so

ntune also says the voltage is at 1.1 or something and im left with a 1.1ghz A64 lol

should i just flash back to default or are there any better bios's in between? hows the new 2/3 beta one?

also, on boot up and adjusting volume in windows, along with system alert pop ups the motherboard makes a pc speaker like noise, but my pcs isnt plugged in, wtf makes that noise?

input V here V

 

[Oceanic]

cleard it a time or two, now at 225x9. fluke?

 

[Hott Nikkels]

You have problems god himself cannot fix.

Might wanna try asking Majorpayne though as he uses and is very successful with the Chaintech VNF4...

 

[MajorPayne]

I too had a problem when I initially flashed to the 2.0 BIOS. Once I manually cleared CMOS (using the reset jumper), it registered CPU speed, voltage, etc. correctly. I think you had the same issue that I did, and it SEEMS to be that the 2.0 BIOS requires a flash after install before you use it, or you will get junk data (as you and I both did). I have not heard from many others with this issue tho, so maybe we are just the lucky ones! Is your problem all fixed now, or do some things still not read right?