Celeron 633 @ 1063 mhz

[WalkingDead]

My Celeron 633 is one of those $80 Onvia batch. FPO/Batch#: Q033A152. SL3W9. Malay.


I'm using a water-cooled 55W peliter on it. The FSB is 112mhz & the Vcore is at 1.8V (the lowest my mobo can goes). The CPU is on a Asus S370-L slocket. The motherboard is a 2 year old Asus P2B rev 1.02 w/ 1012 BIO version. I hit 1063 mhz at the 1st attemp & so far it's very stable after couple of hours in Win98.

Other stuff in my system:

ELSA Gloria II 64mb AGP
Initio dual channel UW SCSI + Intel NIC
SB 16
Motorola ISA hardware modem
Pioneer 32X slot SCSI CDROM
IBM 13.5 gig 22GXP HDD



Should I try 133 mhz FSB (which is the only FSB step after 112 in my old mobo)? Or will it blow up my CPU?

 

[jinsonxu]

What's the CPU temperature after running for awhile?

 

[jinsonxu]

If the temperature is acceptable, i'd cross my fingers, set the voltage to 2.0 or 2.1 volts and change the bus to 133Mhz.

 

[The Reaper]

That's sweet! I was wondering what mine would do with a setup like your's. Get back with us about your results. G-luck

 

[WalkingDead]

<< What's the CPU temperature after running for awhile? >>




I don't know becasue my old motherboard doesn't supports on-chip temperature sensor. And due to the usage of a water block, I can't put a flat temp sensor near the die either. Any idea?