can't put geforce 4 into agp slot of abit it7

[maxdido]

Í can't put my gainward 750xp geforce 4 into the agp slot of my abit it7 (rev. 1.00) motherboard. It seems that the agp slot is 3mm (0.11") out of specification. I put the board into the aopen case, connected it with the brass-stud and screws.

Never seen this before?

 

[Jeff7]

I assume the IT7 is in the case?It's more likely that the motherboard and/or case's mounting holes are a bit off center. Usually loosening the screws holding down the motherboard and repositioning it should help. Hope that's all it is.

 

[maxdido]

I have tried that. But it wasn't enough. Today I'm going back to the shop, see what thy say.

 

[Lizardman]

I am sure it will fit. I am assuming you are saying that your vid card cant fit out the slot in teh back of the case. RIght. Do you have removable motherboard tray? If so re position it alittle. Again I cant see why it wouldnt fit. post a link to your case.

 

[zer0burn]

ive got a ti4600 in my it7

 

[syadnom]

I have a Radeon9700 Pro in my IT7, it was a tight fit, i had to loosen mobo screws and ofcenter mount them, i think the IT7 is a bit out of spec, but i did get my 9700 in and functioning properly.