I'am helping a friend with this. Here's what I did:
1) Hooked up the S-Video to an RCA cable and connected it to the Video-in on the TV to L2 for front video input
2) Went to Video Prop's (WinME - 4403 drv) and followed instructions I found on web:
a) disabled dualview mode by un-checking "Enable" for monitor 2 , then apply
b) clicked monitor 1 to select
c) went to advanced -> media center -> nview
e) try to select clone mode, but it is greyed out and cannot be selected
I cannot select the clone mode. We tried a different TV, turned it on/off, re-booted, and everything else I could think of, but still no can select clone mode. Any ideas?
1) Hooked up the S-Video to an RCA cable and connected it to the Video-in on the TV to L2 for front video input
2) Went to Video Prop's (WinME - 4403 drv) and followed instructions I found on web:
a) disabled dualview mode by un-checking "Enable" for monitor 2 , then apply
b) clicked monitor 1 to select
c) went to advanced -> media center -> nview
e) try to select clone mode, but it is greyed out and cannot be selected
I cannot select the clone mode. We tried a different TV, turned it on/off, re-booted, and everything else I could think of, but still no can select clone mode. Any ideas?
Facebook
Twitter