Can't get my Ti200 to sit in my case

[gariig]

I thought I had a DOA Ti200, but after sticking it in my old computer I realized that there was something wrong with my case. Basically, the problem is the back plate is a little bit too long, I'm talking 1/10th of an inch or so, maybe less which is making it so the card won't sit properly in the AGP slot. I've thought about just hack sawing part of it off...I haven't called Visiontek YET...I just wanted to see if anyone has run into this problem.

needed specs:
Antex KS188+PP303X (the mid tower)
Iwill KK266 (KT133a) board

If anyone has an easy way of fixing this..the input would be useful

Gariig

 

[J3anyus]

Try remounting your motherboard in the case, that's my only guess.

 

[gariig]

bump for the morning

 

[haut]

I'm going to have to agree with J3anyus that the motherboard needs to be shifted. This could be very simple, just unscrew (a little) each mobo screw just enough so you can shift it around. Then shift it so the cards fit (make sure all PCI slots fit too) and tighten the screws back up. Good luck.
--Ryan