Originally posted by: ViperXX
Yes, so to protect your equipment buy a grounding block connector and run a high gauge copper wire to a grounding rod pounded into the ground.
And I doubt anyone without the proper equipment can drive a grounding rod deep enough to do the job. (Forget the actual depth needed but think at least 8 feet and with the proper soil conditions also)
Just ground to copper water pipes and hope for the best. So far Ive not had any trouble with any equipment doing it that way.
Most places in the US should have local regulations that control household grounding practices. The installer usually runs to the electrical and or phone ground for protection.
If you?re in doubt get someone to inspect it. And yes, improper grounding along with a lightening hit can kill all of your electrical and biological systems.
So far you have been extremely fortunate using copper plumbing for a ground. The use of plastic drainage and water pipes tends to isolate older houses from a good ground. The NEC covers this issue. Your much better off using the power ground if you have safe access.
BTW
I am my companies bonding and grounding SME for North Florida. Factoid the Daytona area experiences more lightening hits than anywhere else in the contiguous United States.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.