BSOD Error at startup. help!

aceman817

Senior member
Jul 15, 2001
204
0
0
hey guys. i have this 600mhz Dell laptop that i put xp pro on a while back and it has been running fine up until a few days ago. i have been getting a blue screen that says:


A problem has been detected and Windows has been shut down to prevent damage to your computer.

If this is the first time you have seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:

Check to be sure you have adequate disk space. If a driver is identified in the Stop message, disable the driver or check with the manufactuer for driver updates. Try changing video adapters.

Check with your hardware vendor for any BIOS updates. Disable BIOS memory options such as caching or shadowing. If you need to use Safe Mode to remove or disable components, restart your computer, press F8 to select Advanced Startup options, and then select Safe Mode.

Technical Information:

** STOP: 0x0000007E (0xC0000005, 0xC0000128, 0xFC8DB4A0, 0xFC8DB1A0)


Here's what I've done so far:

1. Tested hard drive - passed
2. Booted Safe Mode ok and scanned for viruses - nothing, removed sound and video drivers and rebooted.
3. Ran chkdsk/r from recovery console.
4. As a last resort i tried a repairitive or install over the top and now i can't even load safe mode.

Any ideas? the unit has adequate disk space and there are not bios updates available.

Thanks,
AL
 

aceman817

Senior member
Jul 15, 2001
204
0
0
well so far memtest didn't find any errors and the unit boots fine to both knoppix and barts pe. any other ideas?
 

montag451

Diamond Member
Dec 17, 2004
4,587
0
0
best run memtest overnite. The aim is to find errors. I know, I know, its tempting to say that it has run a couple of hours - AOK, but that might just hide the problem if the prob is RAM.

Also, Do you remember doing anything with the lappie? Installing, uninstalling, adding/removing, dropping, sharp tap to the casing etc?
Overheating, being kept in cold place, then switched on, then stored in cold place again [causes condensation]?

What were you doing when errors started?

What does Event Viewer say?
Look up all " ? " and " X " and supply us with some SOURCE and EVENT IDs with the text