brake master cylinder or brake booster.. also how to remove stripped bolt which has both ends connected???

[manuelku]

yea of course, I actually bleed my brake before I got the new MC... but it didn't solve the problem, the brake still sink so I got the mc

 

[Brutuskend]

Heat does wonders.

Get a propane torch and heat that puppy up, then use your vise grips (if you MUST) or go to a parts store and buy a brake line wrench.

I assume it IS the brake line fitting you are talking about?

 

[manuelku]

I put in some PB blaster and use a flare wrench.. still not luck.. how much does mechanic charge to take off that bolt??? I can freaking break that old MC into pieces I just need to get that bolt off.. is there something call flare nut or something so I can screw it in and then push out the screw???

 

[Brutuskend]

^
.
.
.
.

HEAT

 

[manuelku]

ha, I used a hammer and lots of PB blaster soaking and a $20 bux vise grip.. it came right off thanks guys