Bloodrage OC problem, hang after POST

[TurK-FX]

Hi guys. i just flashed the bios by using livefox utulity. Not i cant overclock over 150BCLK. Before the flash i had it running at 4ghz with stock volt.

The problem is weird. It boots, does POST check and right before Win 7 loading screen, it stays at black blank screen and cursor flashing on Left upper corner. I know it is not the stability problem but i dont know what is the problem. I really know well about OC. i overclocked I7 to 4.6ghz on P6T deluxe but i am new to Foxconn X58 boards.

 

[Mod7PCs]

Well if I where you, I think I would flash your bios back to what it was and see how it runs. You sound like an experienced overclocker so I am sure you went through and reset settings and all of that so no point going through all of that. I know nothing about Foxconn boards and that is the reason I suggested this route.

Also is the Livefox utility one that you use in windows? If so maybe reload the new bios while in bios. If it isn't a windows utility see above

About all the help I can offer

Dominic

 

[TurK-FX]

i did it several times. Flashed to old bios and lastly i tried flashing on Dos with usb drive. no luck so far.
Since it has 2 bios, will try to switch to second bios

 

[Infrnl]

What bios did you try flashing to? I think the only ones you want to use are P06, 09, & G25. I am not sure if you are a member but there is pretty good support on XS for this board. I am still using P06 on mine. You have to be careful when flashing the bios to make sure you do not overwrite the original. If you look in the manual it will tell you which jumper to switch for the backup bios