I recently picked up that ECS Nforce 2/ Barton 2500+ combo at frys. It runs stable at 200 FSB/ 3200+ speeds. The problem is my ram runs high timings to pull it off. I was wondering if anyone else is running this same board and if there were some bios options to make it perform better. That is besides changing the ram and going higher on FSB. I know its probably the same as with P4 boards but I was hoping for quick advice on what settings to change for better performance. There's probably not much since there's no volt adjusters and stuff....
TIA
-show
TIA
-show
Facebook
Twitter