To All Hardware GURUs
PLEASE READ this long info,
I urgently need any help on this problem,pleease.
the story is, last week i tried to turn on my old pc( a Intel P3 440BX raffles, 666mhz, 192MB ram, 60GB ..) after some time. it got dual boot(XP & 98) when i selected XP it showed the blue scrn o D, and told to reinstall xp, in 98 it said link to Vxd (or something like that) invalid.
then i formatted the C: and tried to install XP and 98 but both said there were some missing files and in xp said PCI.Sys was not there and etc. then i plug the hard Disk to my new pc (without new hard ) there were some virusses and trojans, i cleaned them and installed both 98 and XP without any problem.
Then I plugged the old hard to old pc and start, dual boot screen was there but when selected either OS it had errors and said to reinstall.
i thought it was because of some bios problem and tried to update bios. i found some 440BX bios and copied to a floppy and started updating.
first saved my old bios to floppy and then updated it, after the update (progress bar was 100%) it said press F1 to reset and F10 to exit. i pressed f10 few times but nothing and F1 few times notrhing happend. after some time i had no choise other than reset/reboot the pc by front panel button.
at boot screen first it said BIOS ChECKSUM ERROR!. it was on dos mode so i tried to re update bios and again it was stuck at finish line(progress 100%)
few times this happened and then i turned off pc and tried to clear CMOS by the jumper. and plug it again rightway.
After that i tried to boot but the screen dont show anything, its on standby mode, CPU's both LEDs (HDD and Power ) are on, checks CDrom and floppys but No BIOS OK beep, nothing !. it just stays that way while and then HDD led off.
I really want that pc to work.BTW i am not in USA or europe so prices of pc are not very low here (evan those old ones) so i cant forget it( cause before few months it worked very well)
1.Why the screen doesnt work? is there anything i should look for( the VGA Fan is woking, i tapped on vga it wasnt loose)
2.what should i do ??
3.i took off ram and booted then it beeped, doesnt it shows BIOS is working?
Thanks.
				
		
			