BH6 with older 1.0x rev can't use CPU that requires 10A from the low voltage regulator???????

[John P]

Quote by "nam ng" from a previous thread discussing upgrading processors on the BH6:

"If your bh6 was the older 1.0x rev, do not upgrade to any CPU which require more than 10A from the low voltage regulator, it'll burn-out, later bh6 revision is possible."

How do I know which CPU's require 10A??

 

[bacillus]

10A sounds far too much for a psu to supply unless it was a 1200W psu! :Q
are you sure it wasn't mA??

 

[JackMDS]

I run a BH6 with P-III 1G @ 112x10=1120 MHz. You can not get better.

 

[John P]

Dunno much about amperage, A or mA, I'm just a dumb structures engineer

Here is a link to the previous thread:

Previous BH6 thread