Bh6 & 1.0 gig celery success

[4thman]

We worked on it yesterday, had to use a generic slotkit Super Slotket III.Bh6 1.1 board,NK bios.We are waiting for a friend to upgrade his bios,as I didn't want to screw it up.Used the settings I saw posted here(except for the new bios,SP?)Boots up as a PIII 856 mhz,SiSandra says1.0 gig celery.Is it running at its rated speed?Other than that seems good.The retail intel hsf combo,that came with the new celery was too big.The heatsink hit the ps on one side and the green chipset heatsink on the m/b.We are gonna get the heatsink machined down at work.Using his old intel hsf from his 433 celery,will it be ok until we put the new one on?

 

[oldfart]

Its running at rated speed. The SP BIOS will fix the PIII 856 mhz thing. You should be able to easily overclock it higher. Start with 112 FSB = 1.12 Ghz.

 

[4thman]

Not o/cing until,the hsf combo issue is resolved,thanks for your info from all your posts oldfart.Now my system is next,except I have an Asus p2-99b,pretty sure I can do the same,I hope.Any Asus experts here?

 

[oldfart]

One of the kids PC's is a BH6 1.0 Celeron @ 1.12 G. My slocket must be just slightly taller than yours. The HS clears the greenie, but by a very small margin. I think I could fit a couple of sheets of paper in between. The 433 HS as a temp is kind of small. If you have to run it, I'd underclock to a 66 MHz bus, 666 MHz until you get the proper HS on just to be safe.