- Jun 12, 2008
- 4
- 0
- 0
Heres the situation. I put together a new pc and still have yet to successfully power on all the way. Heres the specs.
evga 750i mobo
intel q6600
bfg 8800 gt oc
ocz 1010 w power supply (72w over 4 12v rails)
4gb ocz 1066 ram
2x lite-on multi-drives
500gb wd sata hard drive
Heres what ive tried.
reseating everything
switching psus
running outside case on foam surface
running barebones (cpu, minimum ram, gpu)
reinstalling heatsink and reapplying thermal paste
results
The only way i can get anything to run is with gpu not installed. Everything else runs fine without. With gpu installed without 6pin power everything runs but i get expected beeps. With everything installed board lights flash and fans spin up but promply cut off within 2 seconds. Sounds like a bad graphics card but i have yet to hear back from bfg as they dont pick up phones or email back it would seem. Any input or other ideas would be much appreciated
evga 750i mobo
intel q6600
bfg 8800 gt oc
ocz 1010 w power supply (72w over 4 12v rails)
4gb ocz 1066 ram
2x lite-on multi-drives
500gb wd sata hard drive
Heres what ive tried.
reseating everything
switching psus
running outside case on foam surface
running barebones (cpu, minimum ram, gpu)
reinstalling heatsink and reapplying thermal paste
results
The only way i can get anything to run is with gpu not installed. Everything else runs fine without. With gpu installed without 6pin power everything runs but i get expected beeps. With everything installed board lights flash and fans spin up but promply cut off within 2 seconds. Sounds like a bad graphics card but i have yet to hear back from bfg as they dont pick up phones or email back it would seem. Any input or other ideas would be much appreciated