As I understand it, the Bad Axe 2 mobo has two 4-pin fan connectors, one fore the processor and one for the auxiliary rear fan. It has three 3-pin connectos, for the rear chassis fan, the front chassis fan, and (optional) for the MCH fan. There is a reference to the fan control system automatically adjusting the fan speed for the 3 system fans. Does this refer to those with the 3-pin connector? How does this work?
Also, the manual says do not plug the processor fan into any connector except the one for the processor, which is a 4-pin connector. However, my processor fan (after-market HSF) is a 3-pin fan. Does this mean that short of a fan-mate or other similar controller that the processor fan can only run at full speed?
Also, the manual says do not plug the processor fan into any connector except the one for the processor, which is a 4-pin connector. However, my processor fan (after-market HSF) is a 3-pin fan. Does this mean that short of a fan-mate or other similar controller that the processor fan can only run at full speed?
Facebook
Twitter