Audigy 2 ZS Speaker Configuration ignores subwoofer

[t3h l337 n3wb]

After about an hour of dealing with crappy Creative drivers, I finally got my Audigy 2 ZS installed today. My problem is that whenever I try to use the speaker configuration to balance them out, my sub is silent. I'm using Logitech X-530 speakers. I noticed that when adjusting volume of the speakers, the subwoofer volume bar is the last option. When I keep clicking "next" to get to that option, it just skips right over it. This is very strange. How do I get the speaker calibration to recognize my sub?

 

[Regs]

Both windows and creative sound control panel is set to a 5.1 speaker set up right?

Ones in the control panel under sounds devices -- > speaker set up -- > advanced button
and the other is located in the surround mixer which should be an icon you click on near the windows timer.

Other than that your wires are mixed.

 

[t3h l337 n3wb]

Yes, both are set to 5.1 I have regular 5.1 computer speakers. The front right has the 3 minijack plugs (orange, black, green), and all 5 speakers connect to the sub. I'm almost certain that the audio inputs plugged into the sound card in the correct order. The sub plays fine when I don't use the speaker calibration.

 

[Regs]

I was under the impression it did not work at all.

It works in games, music, and other media but not the calibrator?

For a minute I thought you had a problem. I never had much use for the calibrator but are you using basic or the advanced option?

 

[t3h l337 n3wb]

Advanced. It works when I turn the calibrated settings off.