Can somebody give me a run down on the differences? I'm going to be running the DFI LP NForce 4 Ultra, and so I'm worried about the 24-pin deal.
I know for sure that EPS standard power supplies have the 24-pin connector, and the latest revision of ATX (2.01) has 24 pins as well (www.formfactors.org).
Is there some other fundamental difference between the two standards or will I be fine with either one?
Note: don't reply with just a recommendation as I would prefer to do the research myself and I am actually interested in the differences.
Edit: whoops, this was supposed to go in the case section. well, if anyone here could help me out, I'd be grateful.
I know for sure that EPS standard power supplies have the 24-pin connector, and the latest revision of ATX (2.01) has 24 pins as well (www.formfactors.org).
Is there some other fundamental difference between the two standards or will I be fine with either one?
Note: don't reply with just a recommendation as I would prefer to do the research myself and I am actually interested in the differences.
Edit: whoops, this was supposed to go in the case section. well, if anyone here could help me out, I'd be grateful.
Facebook
Twitter