Attaching Firewire to 8RDA+ and Cable connection questions

[FFactory0x]

Basically I am attaching my front usb and firewire to my Epox 8rda but each bundle of wires are single connectors (The frontside usb header connectors, are individuals. Meaning, 9 seperate connectors.) not a usual pin block.
ALSO, Also, i am connecting the leds, and power cables to the board. Which side is pin one. There is an arrow on each block but is that ground or pin 1??

Firewire (my connectors
TPA+ TPA- No pinout for Firewire
TPB+ TPB-
VG VP

 

[XRaider]

The 5 volt pins go on the VCC's
Case pins for 1 -D and 1 +D go on the 0 Data - and 0 DAta +
and the 2 -D and 2 +D of course go on the 1 Data - and 1 Data +
The grounds are the same way. the Over current of course goes on the Over current one.
That one is easy, the Firewire pins are the pain!
Look at my post here for Firewire example.
or here: Creative for an Audigy Card.

 

[FFactory0x]

Nope didnt help. My board has 2 rows. Each with like 8-10 pins on each

 

[oscoyle]

 

[oscoyle]

epox has pin-out information for the 8rda+ board on their website.My antec case has single pin connectors and I was able to match up the pins using the case manual and the epox website.