++ ATOT official NEF thread part IV ++

Page 8015 - Seeking answers? Join the AnandTech community: where nearly half-a-million members share solutions and discuss the latest tech.

bigboxes

Lifer
Apr 6, 2002
40,381
12,240
146
Finished repairing my home server on Tuesday. Reimaged my OS drive on Tuesday. All but two drives were detected when I finally reconnected them. Took a second look at them today. They were my movie drives. Both are power disable enterprise drives. I thought I had done a work around to get them to spin up. Upon closer inspection I found that the molex to SATA power adapter was disconnected. 🫤

n6kP5kll.jpg
 

Red Squirrel

No Lifer
May 24, 2003
68,531
12,647
126
www.anyf.ca
I need to dust off all my servers, now that my server room is mostly enclosed. Still need to do crawlspace side, then add a small door to get to crawlspace. Once it's fully enclosed I will have better dust control in there. There will be a vent to draw in cold air from the garage crawlspace going through a hepa filter. Ideally, that fan won't need to run all that often but it will be there in case it's needed. Probably put it on a thermostat and have a set point of like 20C in there or something.

Kind of cool that this is actually, a real room now. Not just studs. I put roxul insulation in the walls too, really cuts down on noise. Going to avoid sanding in here as much as I can when I plaster the walls so I might experiment with textured walls.

IMG_20240216_190036.jpg

IMG_20240216_190006.jpg
 
  • Like
Reactions: Pohemi and bigboxes

bigboxes

Lifer
Apr 6, 2002
40,381
12,240
146
I need to dust off all my servers, now that my server room is mostly enclosed. Still need to do crawlspace side, then add a small door to get to crawlspace. Once it's fully enclosed I will have better dust control in there. There will be a vent to draw in cold air from the garage crawlspace going through a hepa filter. Ideally, that fan won't need to run all that often but it will be there in case it's needed. Probably put it on a thermostat and have a set point of like 20C in there or something.

Kind of cool that this is actually, a real room now. Not just studs. I put roxul insulation in the walls too, really cuts down on noise. Going to avoid sanding in here as much as I can when I plaster the walls so I might experiment with textured walls.

View attachment 94335

View attachment 94336
Did you upgrade your HDDs? I remember you saying you had all these small drives.