ATITool is going NUTS!

[SketchMaster]

In a nutshell. I reloaded my computer, loaded 5.11 and ATItool. Ran ATItool and just for kicks, scan for Artifacts.

It went ape on me. Half the block was highlighted.

Thing is, I don't see any Artifacts. What the heck is going on?


Image.


Edit: After playing a few more games, I found that I was getting artifacts. Looks like I did fry my card.

POOP!

 

[SketchMaster]

Bump

 

[Fraggable]

Well does it work in games? do you ever see artifacts? what card is it? maybe your card doesn't work well with 5.11 drivers.

 

[SketchMaster]

Video card is a X800 GTO2 (modded). Haven't played any games yet.

I never had issues before I reloaded windows, so it might just be that ATItool doesn work with 5.11

 

[ITPaladin]

I run with 5.11 on connect3d gto with no problems. I never see it show the yellow spots long enough for me to see though.
It will bleep but only flash for a moment so I have no idea where they appear.

 

[Munky]

Artifacts? You could be OC'ing too far or it's overheating

 

[SketchMaster]

Video card is at default and it's not overheating. I just ran Counter-Strike:Source and it looks fine sop I'm guessing it's just ATITool doesn't like the new drivers.

 

[DJSfurry]

I have the same card. its working fine with the new 5.11 drivers, and arent the yellow highlights actually artifacts? either way if its working in games etc, then its fine! how high can your clocks get to? im at 533/606

 

[SketchMaster]

I'm at XT PE speeds. It can probly go higher but don't really like to push my card as far as it can go, Blew out my 9800 doing that.

 

[SketchMaster]

After playing a few more games, I found that I was getting artifacts. Looks like I did fry my card.

POOP!