Hi Everyone,
On Sunday I updated my PC with an i5-4690k & Asus Z97 Sabertooth mark 2 combo. Went through the installation and update with minimal issues. 24 hours later while playing a PC game, the rig hit a blue screen of death and crashed. Computer currently will not reboot or get to BIOS.
The mobo only has onboard HDMI/display which makes troubleshooting difficult as both of my monitors are VGA, and I must run an HDMI out to my living room TV.
Specs:
EVGA Gtx760
Asus Z97 Sabetooth Mark 2
Intel i5- 4690k (Stock fan, no overclocking)
G skill 2x8 ddr3 1600
kingston 120gb
1tb HDD
Troubleshooting so far:
- Bios updated to current version after install Sunday.
- All chipset and graphics cards drivers updated.
- Unplugged and replugged all components.
- Case standoffs in correct position, no shorts on board to case.
- Pulled GPU and ran the mobo directly through HDMI to a TV, still no output. (No VGA on the mobo card)
- Reseated ram, no issues with mobo passing ram verification test (Mem OK! blinker).
- Cleared the CMOS via switching the jumpers and by pulling the battery for reset.
At this time, the PC fires up and sounds like it's booted normally, but has no display.
On Sunday I updated my PC with an i5-4690k & Asus Z97 Sabertooth mark 2 combo. Went through the installation and update with minimal issues. 24 hours later while playing a PC game, the rig hit a blue screen of death and crashed. Computer currently will not reboot or get to BIOS.
The mobo only has onboard HDMI/display which makes troubleshooting difficult as both of my monitors are VGA, and I must run an HDMI out to my living room TV.
Specs:
EVGA Gtx760
Asus Z97 Sabetooth Mark 2
Intel i5- 4690k (Stock fan, no overclocking)
G skill 2x8 ddr3 1600
kingston 120gb
1tb HDD
Troubleshooting so far:
- Bios updated to current version after install Sunday.
- All chipset and graphics cards drivers updated.
- Unplugged and replugged all components.
- Case standoffs in correct position, no shorts on board to case.
- Pulled GPU and ran the mobo directly through HDMI to a TV, still no output. (No VGA on the mobo card)
- Reseated ram, no issues with mobo passing ram verification test (Mem OK! blinker).
- Cleared the CMOS via switching the jumpers and by pulling the battery for reset.
At this time, the PC fires up and sounds like it's booted normally, but has no display.