Are these good for a first WC loop?

[Killamaker]

I have this list of parts:
http://www.frozencpu.com/manage_carts.html?view_cart=Yep:1329889226:r&mv_action=return
I only plan to do my GPU with a custom loop, because my CPU runs cool enough as it is. Anyway, are these good? If not, ould you link me to a different site or different links for better parts.
Thanks. 😎

 

[billyb0b]

link is broken

 

[OVerLoRDI]

Linking directly to your shopping cart is a no go. Either screenshot it, or provide us with links to each part.

Also, welcome to getting "wet" 😎

 

[Killamaker]

Haha, thanks ^_^
Yeah, I didn't think it would. Thought it would have been public or something. But here are the links to the parts:

Radiator: http://www.frozencpu.com/products/4...e_GT_Stealth_240_X-Flow_Radiator_-_Black.html

Pump/Res: http://www.frozencpu.com/products/1...ool_VPP655_Variable_Speed_Pump_Installed.html


GPU Block: http://www.frozencpu.com/products/1...Rev_11_EK-FC570_GTX_SE_-_AcetalEN_Nickel.html

And they all have standard 1/4 ID barbs to go with them. And Ill be getting 1/4 ID 3/8 OD tubing.

And I know I'll need some fans and I seem to remember a bit about them, but I am not too sure.

 

[OVerLoRDI]

I think you are confusing G1/4 THREADING with tube diameter. These are different things.

What case?

Perhaps a different radiator with lower fpi so you can use less powerful and thus less noisy fans.

Also take a look at this:
http://www.clunk.org.uk/forums/water-cooling/33772-water-cooling-guide-beginners.html

 

[Killamaker]

I propbably did confuse it... But the fittings that into the parts are 1/4: http://www.frozencpu.com/products/1...rome_G14_Barb_Fitting_-_14_ID_BP-WTP-C12.html

And the tubing is this: http://www.frozencpu.com/products/2123/ex-mis-03/14_ID_-_38_OD_PVC_Clear_Tubing.html

And yeah, the case... Uhm, I'm putting it in a desk that is being built.
Oh, are the pump+res' good parts?

Thanks for the link to the guide too.

 

[OVerLoRDI]

Are those the barbs you are buying? I'd recommend using 1/2" or 3/8" barbs and tubing.

Ill have to double check, but i would be really really surprised if those parts came with barbs and came with 1/4" barbs. Basically no one uses 1/4" barbs.

The pump/res looks fine.

 

[Killamaker]

Okay. So get 1/2 barbs and 1/2 tubing? I was wondering why the barbs look so small for tubing. And I changed my mind after reading that guide, I chose a different pump. Mostly cause it would be easier to work with:
http://www.frozencpu.com/products/1...0_-_Acetal_-Laing_DDC_Swiftech_MCP350355.html