first of all it was a nice experience working with drive rails and those 3.5" cages. i never had to remove the second side panel during the entire installation of all my components. One anoying thing I notice that wasn't mention in any of the reviews I read was that the reset button is really small and you probably need a pen to press it.
However its cooling performance makes up for that. I am just running the 2 stock fans that came with it and mounted a 60*60 quiet fan inside the case to move some air around the cpu/chipset area. I expected that with this setup the case temp would be around 5 to 10c higher than ambient but to my surprise case temp is just less than 1f above ambient temperature(right now its .1 f above it so this is probably negligable) and this is all with a closed case. I was planning mod this case to increase its cooling performance but there doesn't seem to be any need for that now. You can view my system in my sig and my guess is that if you have a more demanding system then you need more cooling. adding 2 fans in the bottom front would be a good start.
However its cooling performance makes up for that. I am just running the 2 stock fans that came with it and mounted a 60*60 quiet fan inside the case to move some air around the cpu/chipset area. I expected that with this setup the case temp would be around 5 to 10c higher than ambient but to my surprise case temp is just less than 1f above ambient temperature(right now its .1 f above it so this is probably negligable) and this is all with a closed case. I was planning mod this case to increase its cooling performance but there doesn't seem to be any need for that now. You can view my system in my sig and my guess is that if you have a more demanding system then you need more cooling. adding 2 fans in the bottom front would be a good start.